Genie Garage Door Openers

Expansion Modules / Monitored Edge Interface Module

 

Timer Close Module (TCM)

OPABTCGX.S

Requires Monitored Entrapment Device To Be Installed

Timed Close

Adjustable from 1 second to 5 minutes.

Timer Hold Input

Allows for switch input to hold timer

Pre-Close Warning Output Contacts

Adjustable from 2 to 10 seconds prior to close.

Auxiliary Open Input

Provides additional open input that can be confi gured to start timer.

N-C Normally Closed Safety Input

Non-monitored N-C edge or photoeye input.

Monitored Edge Input

Provides contacts to connect monitored edges.

Plug and Play

Plugs directly into control board expansion port, and can daisy chain with additional expansion modules.

Set-Up

LCD display is used to adjust settings and selection of inputs to start timer.

 

Auxilary Output Module (AOM)

OPABIOGX.S

Up Limit Output

Contacts activate when door reaches up limit. N-O, and N-C contacts included. Two sets of single-pole double-throw (SPDT) contacts.

Down Limit Output

Contacts activate when door reaches down limit. N-O, and N-C contacts included. Two sets of single-pole double-throw (SPDT) contacts.

Mid-Stop Limit Output

Contacts activate when door reaches mid-stop. N-O, and N-C contacts included. One set of single-pole double-throw (SPDT) contacts.

ADA Output

Contacts confi gurable via LCD to activate when door is moving open, closed, or both open and closed. One set of single-pole double-throw (SPDT) contacts.

Lamp Output

Contacts activate when door is set into movement and has a five-minute delay before turning off. One set of single-pole double-throw (SPDT) contacts.

Plug and Play

Plugs directly into control board expansion port, and can daisy chain with additional expansion modules.

Set-Up

LCD display is used to adjust ADA output.

 

MONITORED EDGE INTERFACE MODULE

OPAKMEIGX.S

Interface

Allows connection of 2-wire ā€œDCā€ or ā€œT3ā€ monitored edge to ODC STB inputs on main control board.

Alternate

Aside from TCM module, the interface module is the only other way to connect a monitored edge to an operator.